Skip to content
← Brew guides

Hario V60

V60 pour over

The cup we brew by hand behind the bar: clean, clear and easy to repeat at home. You need 15 g of coffee, 250 g of water and about three and a half minutes.

Ratio
15 g coffee to 250 g water
Grind
Medium-fine, like coarse sand
Water temperature
93.5 °C
Total time
3:30

What you need

  • Hario V60 and paper filter
  • Grinder (we use a Fellow Ode)
  • Scale with timer
  • Gooseneck kettle
  • Server or cup

How we do it

  1. 1

    Rinse the filter

    Put the filter in the V60 and rinse it with hot water. It takes away the papery taste and warms everything up. Pour the rinse water away.

  2. 2

    Grind and weigh

    Grind 15 g of coffee just before you brew, tip it into the filter and shake gently so the surface is flat. Put it all on the scale and zero it.

  3. 3

    Bloom

    Start the timer and pour water in small circles until all the coffee is wet. It bubbles a little as the carbon dioxide escapes. That is the bloom.

    0:00–0:45 · 45 g total on the scale

  4. 4

    First pour

    Pour steadily in circles from the centre outwards, without hitting the edge of the filter.

    0:45–1:15 · 150 g total on the scale

  5. 5

    Second pour

    The same steady circles until the scale reads 250 g. Give the V60 a gentle swirl afterwards so the coffee settles flat.

    1:15–1:45 · 250 g total on the scale

  6. 6

    Let it run through

    Wait until the water has run through the coffee, then lift the filter off. The coffee left in the bottom should lie flat, not in a cone.

    1:45–3:30

Tastes off?

If the water runs through much faster than 3:30 and the coffee tastes thin or sour, grind finer. If it takes much longer and tastes bitter and drying, grind coarser.

Which beans?

We brew with the beans we have in the coffee bar right now. Ask behind the bar and we will find one that suits your taste.